Volume 13, Issue 1 (6 2000)                   jdm 2000, 13(1): 34-42 | Back to browse issues page


XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Fazel A, Gerami Panah F, Zaratti S. Stress Distribution Around Dental Implant Influence of Various Crowns- Fixture Ratio. jdm. 2000; 13 (1) :34-42
URL: http://jdm.tums.ac.ir/article-1-534-en.html

Abstract:   (2466 Views)

Preservation of bone-implant interface is vital for maintaining of implant treatment. There are some cases in which crown to fixture ratio is increased due to loss of residual ridge. In this condition knowledge of stresses acting over alveolar bone is important in regard to prognosis of treatment. In this study three different crown to fixture ratios evaluated under lateral forces considering stresses generated in the alveolar bone around the implant.Three different models of crown to implant ratios were designed in a single-tooth implant at anterior maxilla.Model No. 1 with ratio of 1:1, model No. 2 (1.5:1) and model No. 3 (2:1) were designed. Then, the differences between stresses under two horizontal loads (70 and 100 Newton) were analyzed by three-dimensional finite element analysis. Principal normal stresses and Vonmises stress were measured in this study.Results indicated that stress concentration were mainly at the crestal bone.Highest stresses were obtained in third model (2:1 ratio), which was approximately twice as first model (1:1) ratio.

Full-Text [PDF 810 kb]   (869 Downloads)    
Type of Study: Research | Subject: general
Published: 2013/07/31

Add your comments about this article : Your username or Email:
Write the security code in the box

© 2017 All Rights Reserved | Journal of Dental Medicine

Designed & Developed by : Yektaweb