Volume 15, Number 2 (8 2002)                   jdm 2002, 15(2): 5-17 | Back to browse issues page


XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Jafarzadeh T,  Erfan M, Watts D, Cash A. Polymerisation shrinkage versus layer thickness of a dentine bonding resin: Method development. jdm. 2002; 15 (2) :5-17
URL: http://jdm.tums.ac.ir/article-1-454-en.html

Abstract:   (16831 Views)
Dentine bonding systems are usually unfilled, and so their shrinkage may be significant. High shrinkage may cause internal stress at the interface between resin-composite restoration and the dentine substrate. Failure of the adhesive interface may be observed due to the interna! stress. The aims of this study were:A) To obtain a suitable method for measuring the kinetics of polymerisation shrinkage in unfilled resm at different thicknesses, particularly for thin films.B) Consideraing the effect of thickness on shrinkage.Scotchbond Multipurpose (3M) adhesive bond resin was used. To overcome the particular challenges presented by thin films, a filled-ring measurement procedure was used. Also, a non-contact laser analogue displacement sensor system was developed and applied to measure polymerisation shrinkage. Regression analysis was performed on a complete data set. Non-linear regression analysis established a logarithmic relationship between polymerisation shrinkage and layer thickness. The method applied in this study was found to be sensitive and accurate procedure for determining photo-polymerisation shrinkage of thin films. Polymerisation shrinkage increased with logarithmic of the adhesive thickness.
Full-Text [PDF 934 kb]   (1449 Downloads)    
Type of Study: Research | Subject: general
Published: 2013/09/18

Add your comments about this article : Your username or email:
Write the security code in the box

© 2017 All Rights Reserved | Journal of Dental Medicine

Designed & Developed by : Yektaweb